![]() ![]() To use, weld your hardy tools to the head of different bolts.įill a large metal bin (or trash can) with water until almost to the top and keep a hose nearby. Tighten a bolt and nut through the overhang with the bolt on top, and weld the nut in place on the underside. It's impossible to drill a square hole, so instead drill a 'round' hardy hole measuring approximately 5/8″. Drill a hole about 5/16″ in size – this will be your anvil's pritchel hole, This will take a few rods and a lot of heat!Īfter welding, cut the end of the spring section off about 4″ from the rear (away from the horn) end of the track.Ī real anvil has two holes – a square one, called a hardy hole, and a round one, known as the pritchel hole. Because of the curve, the rest of the spring will be higher than the top of the track.įlatten the spring section to the top of the track using clamps. Spot weld it in several places, then remove your clamps and weld the two pieces together. Once your spring section is cool enough to handle, weld the square, forward end to the base of the horn – the point where the triangular horn becomes the same width as the rest of the track. This annealing process will remove the stress from the molecules of steel, allowing it to be easily bent and not spring back. Remove the temper from the steel to make it flat and stay that way – this process is called annealing. The simplest way to do it is to cook it in a forge until it gets red hot (literally), then take it from the heat and bury it in a big pile of ashes. This is where the section of truck leaf spring comes in. Make a flat surface on the top of the anvil. A torch would be most ideal – it is easy to manipulate and saves a lot of time. Soften the metal with fire for easy cutting and shaping. Shape the railroad track roughly into an anvil shape.īasically, an anvil shape amounts to a horn on one end and a square on the other end. Find a good piece of railroad track scrap This post is an adaptation of Instructables' Railroad Track Anvil Materials Needed Which is exactly why we've created a DIY anvil tutorial to fulfill your blacksmithing dreams without emptying your bank account.įollow the instructions below to make your own homemade blacksmithing anvil Buying blacksmithing equipment, however, is expensive and the proper supplies can be hard to find. Blacksmithing is a useful trade on a homestead and can be a very stress-relieving hobby. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |